Tag Archives: suspensive conditions

Suspensive conditions in a deed of sale: Know your obligations

A3_GTImagine signing a deed of sale for your dream house and later discovering that the contract lapsed because you obtained bond approval one day too late. The situation could be worsened if the Seller receives a better offer for the house and accepts that better offer.

If a deed of sale is made subject to a suspensive condition it will lapse if such condition is not fulfilled in time. This was confirmed in the case of Marais v Kovacs Investments 724 (Pty) Ltd [2009] 1 All SA 174 (C) (hereinafter referred to as “the Marais case”). There is then no contract for the sale of the property between the two parties and the Seller can sell the property to another purchaser.

Examples of suspensive conditions are obtaining bond approval before a certain date, or the sale of the Purchaser’s current property before a certain date. It is very important for both the Seller and Purchaser to take note of the wording of these conditions and ensure that they understand them.

The following is an example of the wording of a suspensive condition relating to a bond, also sometimes referred to as a “bond condition”:

This Deed of Sale is subject to the Purchaser obtaining bond approval from a financial institution for the amount of R1 500 000 before 2 December 2013, failing which this agreement will lapse.

In the above example, if only R1 400 000 is approved before 2 December 2013, in other words R100 000 less than the required amount, then the condition is not met and the contract will lapse. Similarly, if a bond is approved for R1 500 000 but only on 5 December 2013, then the condition is not met in time and the contract will lapse, as was decided in the case of Meyer v Barnardo and another 1984 (2) SA 580 (N).

The parties can however agree to extend the time during which the suspensive condition must be fulfilled. Such extension must be in writing and signed by both the Seller and Purchaser as per the requirements of the Alienation of Land Act 68 of 1981. It must also be done before the time limit of the suspensive condition expires. In the above “bond condition” clause example, this would mean that the parties would have to sign the extension before 2 December 2013 to prevent the Deed of Sale from lapsing. In the Marais case the court held that even if the suspensive condition had been inserted in the contract for the exclusive benefit of the Purchaser, the Purchaser would have had to communicate his intention to waive the requirement before it lapsed.

In the Marais case the parties entered into a written agreement of sale with a suspensive condition that a bond in the amount of R10 149 072 needed to be obtained by 15 August 2005. The Purchaser, however, only obtained a mortgage bond in the amount of R9 650 000, which was granted on 2 August 2005. The respondent’s attorneys argued that the suspensive condition had been substantially fulfilled because the shortfall was, in their opinion, only a “minor shortfall” and therefore an insignificant amount compared to the purchase price. The court did not agree with this and found that it could not be said that the parties intended the suspensive condition to be fulfilled in any way other than what was expressly stipulated in the Deed of Sale. The court found that the contract had therefore lapsed.

If a suspensive condition will not be fulfilled in time, rather take the necessary precautions beforehand to avoid a lapsed Deed of Sale. We advise that you contact a professional for advice in this regard.

References:

  • Kontraktereg, UNISA 2004
  •  Self Study Conveyancing Course for Attorneys, Gawie le Roux, 2013
  •  Alienation of Land Act 68 of 1981
  •  Marais v Kovacs Investments 724 (Pty) Ltd [2009] 1 All SA 174 (C)
  •  Meyer v Barnardo and another 1984 (2) SA 580 (N)

This article is a general information sheet and should not be used or relied on as legal or other professional advice. No liability can be accepted for any errors or omissions nor for any loss or damage arising from reliance upon any information herein. Always contact your legal adviser for specific and detailed advice. Errors and omissions excepted (E&OE)

What does a suspensive condition in a contract really mean?

A2Most people that have bought a property may have noticed a clause dealing with suspensive conditions in the contract of sale. Usually these conditions relate to deposits that need to be paid, financing that has to be procured and/or another property that needs to be sold before the sale can be confirmed. The interpretation appears straightforward enough – meet the requirements, and the contract is valid; fail to meet the requirements and the contract is invalid. But is it really that straightforward? And what are the consequences of non-compliance?

In layman’s terms a condition contained in a contract can be described as a provision that defers the obligation(s) of a party in the contract to the occurrence of some future uncertain event. This is usually termed a ‘suspensive condition’ or a ‘condition precedent’.

Legally a suspensive condition can be described as a condition, which suspends the operation or effect of one, or some, or all, of the obligations under a contract until the condition is fulfilled. If the condition is not fulfilled then no contract comes into existence. Once the condition is fulfilled, the contract and the mutual rights of the parties relate back to, and are deemed to have been in force from, the date of the signature of the agreement and not the date of the fulfilment of the condition.

The Supreme Court of Appeal recently confirmed that where a suspensive condition is not fulfilled timeously it lapses and the parties are not bound by it, even though one party has performed fully.

In the matter of Africast (Pty) Limited v Pangbourne Properties Limited the parties concluded a contract for the development of commercial property in an area in Gauteng. One of the suspensive conditions in the contract was that Pangbourne’s board of directors had to approve the contract and written approval had to be presented to Africast within seven working days from the date of conclusion of the contract. The contract was signed on 11 April 2007 and Pangbourne’s board of directors approved the contract on 20 April 2007, however the written approval was only provided on 25 April 2007 to Africast, which was after the required seven-day period. Pangbourne decided after 18 months that since the suspensive condition had not been met within the stipulated period, it was not bound by the contract and refused to deliver the required guarantees. At that stage buildings had already been constructed by Africast in terms of the agreement.

The Court confirmed Pangbourne’s view that since the suspensive condition in the contract had not been fulfilled timeously no contract had come into existence and that the contract had lapsed due to non-fulfilment of the suspensive condition. The Court came to this conclusion notwithstanding the fact that both parties had performed in terms of the agreement for some 18 months.

The most common appearance of suspensive conditions is in contracts involving the sale of immovable property such as a house, flat, plot, or farm. The conditions that are generally encountered in the contract of sale is that the sale is subject to the purchaser obtaining a bond from a financial institution and/or that the sale is subject to the purchaser selling his existing property within a certain period.

It is important to bear in mind that suspensive conditions are usually inserted in a contract for the benefit of one of the parties to the contract. In the abovementioned scenario, the suspensive conditions are included for the protection of the purchaser. Should the purchaser fail to obtain a bond and/or sell his existing property within the required period, the contract would not have any force or effect and the purchaser will not be bound to the terms and conditions of the contract. Non-fulfilment of a suspensive condition renders the contract void and should the parties still wish to continue with the sale, a new contract of sale must be concluded.

If a suspensive condition is included for the benefit of a particular party to a contract, such suspensive condition can be waived at any time prior to the lapsing of the time for the fulfilment of the suspensive condition by the party for whose benefit the condition was included. Having regard to the scenarios mentioned above, the purchaser may accordingly at any time before the lapsing of the period of the suspensive condition, inform the seller that he waives the suspensive condition and the contract is no longer subject thereto. This will then make the contract unconditional and the purchaser and seller will be bound to the terms of the contract.

It is always prudent to tread carefully when entering into a contract that is subject to a suspensive condition. Be aware of the stipulated periods for compliance, for whose benefit the conditions are inserted and the requirements to prove compliance. If necessary, ensure you seek legal advice before you sign the contract and obtain advice before you waive any conditions that have been inserted for your benefit.

This article is a general information sheet and should not be used or relied on as legal or other professional advice. No liability can be accepted for any errors or omissions nor for any loss or damage arising from reliance upon any information herein. Always contact your legal adviser for specific and detailed advice.